User:Boesecke

From canSAS
Revision as of 09:08, 19 July 2012 by Boesecke (talk | contribs)

Go back to 2012_Data_Discussion

Peter Boesecke (ESRF, Grenoble)

The discussion in what format small angle scattering data should be saved is already going on for many years: XML, HDF5, NEXUS etc. I am convinced that this is not the most important question that must be answered. If somebody would decide: "It is BXHN" (just a name) I would not feel better because the most important part would still be missing: What data must be saved, what data are needed for analysis? As beamline scientist and local contact at X-ray scattering beamlines I have always tried to save as much useful metadata as possible together with the (2D) scattering data. The parameter set was evolving with time and I have tried to make sure that the parameters do not become contradictory and that they remain well-defined. Many metadata parameters are not needed very often, e.g. proposal number, but some others are, e.g. wavelength and beam center.

As internal reference a standard geometry of a small angle scattering experiment has been chosen where the position sensitive detector (1D or 2D) is perpendicular to the primary beam (required metadata: pixel size in each direction, wavelength, distance, beam center). The use of regions of interest and binning must be supported without complicated recalibration. It should be possible to analyze in a similar way standard geometry data and data from more complicated geometries, e.g. inclined detectors. Therefore, parameters are added that default to the standard case when not specified. An inclined detector is described by additional rotation angles that are zero when not defined. It becomes necessary to distinguish clearly between beam center and point of normal incidence. Sometimes it can also become more comfortable to look to the data in a different way, e.g. to construct a physical detector mask. In this case distances in mm are much more adequate than in 1/nm.

It must be possible to extract the described SX-parameters from a SAS file independent of its format (task: what are the corresponding NEXUS parameters?). How could/must they be saved after refinement, e.g. in a standard SAS file? I surely do not want to overwrite any raw data, e.g. the monochromator rotation. It would be sufficient to save all SX-parameters or a SAS file standard parameter list that contains them, at least implicitly.

For statistical error propagation calculations I propose to store, optionally, the variance of each pixel (see: Peter Boesecke, "Reduction of scattering data" J. Appl. Cryst. (2007). 40, s423–s427)

Additionally to describe a given experimental geometry it should be possible to save experimental conditions (temperature, pressure etc.) in a defined way and to look-up experiments in a data base. But this is out of the scope of this contribution.

The above description is suitable for pinhole type experiments with linear and area detectors. Other detector types or different experimental configurations may need additional information. Whenever possible the descriptions should converge for limiting cases, e.g. the description of cylindrical detector geometry should converge to the description of linear detector geometry when the cylindrical radius approaches infinity. Linear and area detectors should be limiting cases of cylindrical and spherical detectors.